Jackets, pants, gloves and boots are usually stored badly because they are stored in a hurry. They go into a cupboard damp, under a bag, on a hot floor or into a top box for a season. The damage is slow: mould in a lining, a crushed armour pad, a seized zip, leather dried into creases. A few habits keep gear ready to wear and protect what you paid for.

Where each item should live

ItemStore itKeep it away from
Leather jacketWide hanger, breathable coverWire hangers, heat, plastic bags
Textile jacketHanger or loose fold, dry roomCompression, direct sun
GlovesFlat, fingers straight, cuffs openHelmet interiors, radiators
BootsUpright with trees, insoles outHeaters, damp floors
ArmourFlat and uncompressedWeight, hot cars
Rain suitLoose fold or hangerVacuum bags, packed top boxes
HelmetCool shelf, breathable bagSee the helmet storage guide

Moisture first, everything else second

Sweat and rain are the two things gear brings home. Left in a lining, they feed mould, corrode metal zips and snaps, rot cotton stitching and turn leather musty. Foam armour absorbs water and holds it against the shell. Gear that smells musty when you open the cupboard is already growing something, even if the outside looks clean.

Dry everything before it is stored. Hang jackets and pants in shade with moving air, and leave gloves and boots where air can circulate through them. A fan is better than heat, because heat damages leather, foam, glue and membranes. If gear came home soaked, deal with it that evening rather than the following weekend.

A simple routine beats a deep clean once a season. When you come home, empty your pockets, hang the jacket where air can reach it, and stand your boots up rather than dropping them in a corner. Gloves go flat on a shelf, not inside the helmet. Five minutes at the end of a ride prevents most of the damage that careless storage causes over months.

Jackets and pants

Hang a leather jacket on a wide, shaped hanger that supports the shoulders. A wire hanger leaves a peak in the shoulder and stretches the leather around it. Textile jackets can hang or be folded loosely, depending on weight and the maker's advice. Empty the pockets, close the zips so the garment keeps its shape, and leave vents open so air can move through.

Pants can hang from the waistband or be folded once at the knee. A sharp fold held for months becomes a crease, and a crease in a laminated membrane is where water eventually finds a path. If a jacket has a removable thermal liner, take it out for the warm months and store it flat with the garment, so it does not crush the shell. Do not compress gear into a packed wardrobe or a vacuum bag, and keep it out of direct sunlight, which fades dye and degrades synthetic fabric.

Gloves and boots

Lay gloves flat with the fingers straight and the cuffs open. Do not crumple them into a helmet, a pocket or the bottom of a bag, where the fingers crease and the palm foam takes a set. If they are wet, dry them at room temperature with air moving through them, and turn the cuffs down so moisture can escape.

Stand boots upright with boot trees, rolled newspaper or the maker's shaper inside, and pull the insoles out to dry separately. Brush mud off the soles and wipe salt and road film from the uppers. Do not dry boots on a radiator or in front of a heater: leather hardens, glue softens and a membrane can wrinkle into a leak.

Armour and protectors

Foam protectors compress permanently under load and heat, and a compressed protector absorbs less energy. Store armour flat and uncompressed, not under a bag of boots or beneath a stack of jackets. If you remove protectors, keep them with the garment in a labelled pocket so they go back in the right place, and check that hook-and-loop retainers still hold.

Hard shells can crack and foam can crumble with age. Compare left and right protectors: if one feels thin, flat or noticeably softer, it has probably taken a set. Replace armour that has lost shape, and check that the pocket stitching has not failed, because a loose protector moves in a fall.

Seasonal storage

Before the off-season, clean the gear according to its labels, dry it fully and check the zips, seams, armour and water-repellent finish. Store it under breathable covers in a dark, stable place, away from exhaust fumes, paint, fuel and mice. Cedar blocks or a maker-approved pest product help in sheds and lofts; vacuum bags and sealed bins do not, because they trap moisture.

Check everything monthly in humid climates. Open the covers, let air move, look for mould at collars, cuffs and linings, and recharge any desiccant. Write the storage date on a note. Ten minutes of inspection now beats discovering a split seam or a seized zip at the roadside at the start of the season.

Checklist

  • Dry every item fully before it goes into storage.
  • Hang leather on a wide hanger and avoid sharp folds in laminated gear.
  • Store gloves flat and boots upright with shapers inside.
  • Keep armour flat, uncompressed and paired with its garment.
  • Clean gear before the off-season and check zips, seams and DWR.
  • Use breathable covers, not sealed bags or vacuum packs.
  • Inspect monthly in humid weather and watch for mould.

Questions

Can I store riding gear in a garage?

Only if the garage is dry and the gear is protected from fuel, paint and exhaust fumes. Many garages are damp and hold solvent vapour that attacks shells, trim and membranes. A cupboard inside the house is usually the better choice for jackets and helmets.

Should I wash gear before storing it?

Yes, if it is dirty or sweaty, but follow each item's care label and dry it completely. Dirt holds moisture and attracts pests, and body oils can stain leather over months. Cleaning at the end of the season also gives you the chance to inspect seams and armour.

How do I stop mould in stored gear?

Dry the gear fully, store it with airflow, keep the space dry and check monthly. Desiccant packs help in closed cupboards if they are recharged. If mould appears, isolate the item and follow the maker's cleaning advice rather than brushing spores deeper into the lining.

Is it safe to store armour inside the jacket?

It is convenient and usually fine if the jacket is hung or folded loosely and nothing presses on the pads. Avoid stacking weight on the armour, and check the pads before the next season. If a protector feels flat or soft compared with its pair, replace it.

Go deeper