Rubber cracks because it loses plasticiser and reacts with oxygen, ozone and sunlight. The result can be a fine surface crazing that looks alarming but does not reach the cord, or a deeper crack that does. The difference matters: surface crazing is an appearance and aging issue, while a crack that exposes cord or runs into the bead is a structural failure. Position, depth and whether the crack grows are the things to inspect.
Crack assessment
| Location | Depth | Action |
|---|---|---|
| Sidewall surface | Shallow | Monitor, keep out of sun |
| Sidewall radial | Deep or growing | Replace |
| Bead area | Any | Replace |
| Tread groove | To cord | Replace |
| Mould seam | Shallow | Usually cosmetic |
Where cracks appear
Sidewall cracks often start near the bead or in the lettering area, where the rubber is thin and flexes. Tread groove cracks start at the base of a groove and can be hidden until the tread wears. Cracks around the valve or the rim are often caused by age or chemical exposure.
Look at both sidewalls, the tread grooves and the bead area. A crack that follows a mould seam is common and usually superficial; a crack that crosses the seam or runs radially is more concerning.
Ozone, UV and chemicals
Ozone attacks stretched rubber, producing small cracks perpendicular to the stress. Sunlight and heat accelerate aging. Solvents, strong detergents and some tire dressings can also degrade the surface.
Store the bike out of direct sun, avoid harsh chemicals and keep the tires clean. A tire that has been parked in the sun for years can crack before the tread wears.
Judging severity
A shallow crack that does not reach cord, does not lift the rubber and does not grow is usually a cosmetic aging issue. A crack that reaches cord, a crack at the bead, a crack that separates the tread or a crack that grows after a few rides is structural.
Do not open a crack with a tool to see how deep it is; you can push debris into the casing. Use a light and a magnifier. If you can see cord, the tire is finished.
Cracking and pressure
Under-inflation increases sidewall flex and can make cracks open and grow. Over-inflation stretches the rubber and can also contribute. The correct cold pressure reduces both.
A tire that has been run flat may have internal damage that is not visible as a crack. If it has been run flat, inspect it off the rim or replace it.
Replacement decisions
Replace a tire with a crack that reaches cord, a crack at the bead, a crack that separates the tread or a crack that grows. Replace a tire with deep cracks in the tread grooves, because water can reach the casing.
Surface crazing on an old tire is a warning to inspect more often. If the tire is also hard, worn or flat-spotted, replace it. Do not rely on a dressing to hide cracks.
Checklist
- Inspect both sidewalls in good light.
- Check tread grooves for cracks.
- Look for cord or a lifted edge.
- Note whether a crack grows over a few rides.
- Keep the bike out of direct sun.
- Replace a crack at the bead or one that reaches cord.
Questions
Are small sidewall cracks safe?
Shallow surface cracks that do not reach cord and do not grow are usually cosmetic aging. Any crack at the bead, a deep radial crack or one that grows is a replacement.
Can I use tire dressing to hide cracks?
No. A dressing can make the surface look better while the crack continues. Some dressings also degrade rubber. Inspect and replace instead.
Does low pressure cause cracks?
It increases sidewall flex, which can open cracks and accelerate aging. Correct pressure reduces the risk.
How old is too old for a cracked tire?
Age alone is not the test. A cracked tire that is also old, hard or worn should be replaced. Follow the manufacturer's guidance and inspect carefully.