A slow leak is any pressure loss that is too gradual to hear. Common causes are a valve that no longer seals, a bead that is not seated against a corroded rim, a small puncture, a porous repair or a cracked rim. The leak may only appear when the tire is warm or under load, which is why a cold soap test can miss it. Finding the path is a process of elimination, and some causes are structural.
Slow leak causes
| Location | Test | Action |
|---|---|---|
| Valve core | Soapy water | Tighten or replace |
| Valve stem base | Bend gently | Replace valve |
| Bead | Soapy water at flange | Clean, inspect, re-seat |
| Tread | Look for object | Repair or replace |
| Rim crack | Visual, dye | Replace wheel |
| Previous repair | Dismount and inspect | Re-repair or replace |
Start with the valve
Remove the valve cap and put soapy water on the valve opening. A stream of bubbles means the valve core is loose, dirty or failed. Tighten the core with the correct tool; if it still leaks, replace the core or the valve.
A rubber valve stem can crack at the base, especially on a bike that sits in the sun. Bend it gently with the wheel supported; a crack will show. Replace an aged rubber valve with the tire.
Test the bead
Soapy water around the bead on both sides will show a bead leak. A leak at the bead is often caused by corrosion, dirt or a damaged bead seat. Clean and re-seat only if the bead and rim are undamaged; otherwise replace the tire or repair the rim.
A leak that appears only when the tire is warm can be a bead that is not fully seated. Have the tire dismounted and inspected rather than adding sealant.
Check the tread and the rim
Look for a nail, a screw or a cut. A small object may seal the hole while it is in place and leak when it moves. Do not pull it out until you can repair or replace.
Inspect the rim for cracks, especially on cast wheels, and for corrosion around the bead seat. A cracked rim is a replacement, not a repair. A bent flange can also prevent a seal.
Porous repairs and liners
A previous plug or patch can seep. A repair that was not done from the inside may not have sealed the liner. If the leak started after a repair, have the tire dismounted and the repair inspected.
A damaged inner liner on a tubeless tire can leak through the casing. This is hard to find with soapy water and may require immersion or a shop test.
When to stop adding air
If the tire loses pressure repeatedly, stop treating it as a maintenance item. A slow leak can become a rapid loss at speed. Find and fix the cause, or replace the tire.
Check pressure cold, record the loss over a few days, and have the tire inspected if the cause is not obvious. Do not use sealant to hide a leak you have not found.
Checklist
- Soap the valve core and stem base first.
- Soap both bead flanges.
- Inspect the tread for objects and cuts.
- Check the rim for cracks and corrosion.
- Record pressure loss over several days.
- Do not use sealant to hide an unknown leak.
Questions
Why does my tire lose pressure but no leak shows?
The leak may only appear when the tire is warm or loaded, or it may be through the liner or a previous repair. A shop immersion test can find it.
Can I use tire sealant for a slow leak?
Sealant can mask a leak and corrode the rim or valve. Find the cause first. Sealant is not a substitute for a proper repair.
Is a slow leak dangerous?
It can become a rapid loss at speed. A tire that repeatedly loses pressure should be repaired or replaced before it is used at highway speed.
Should I replace the valve with the tire?
Replace an aged rubber valve when fitting a new tire. A metal valve can be reused if it is undamaged and seals correctly.