Pressure falls when temperature falls, because air contracts. A tire set warm in the afternoon can read several psi lower the next morning without leaking. But a tire that loses most of its pressure overnight has a leak. The common paths are the valve, the bead, a small puncture, a porous repair or a cracked rim. The test is to separate normal temperature change from a real loss, then isolate the path.
Overnight loss causes
| Cause | Pattern | Test |
|---|---|---|
| Temperature drop | A few psi, stable | Compare cold readings |
| Valve core | Bubbles at valve | Soapy water |
| Valve stem | Crack at base | Bend gently |
| Bead | Bubbles at flange | Soap, warm test |
| Puncture | Slow or flat | Look for object |
| Rim crack | Persistent loss | Dismount, inspect |
Temperature and normal loss
Air pressure changes by roughly 1 psi for every 5-6 degrees Celsius of temperature change, depending on the starting pressure. A tire set at 30 psi in a hot workshop can read 27 psi on a cold morning. That is not a leak.
Set pressure cold, at the same time of day, and compare over several days. A consistent small drop that tracks temperature is normal. A drop that continues after the temperature stabilises is a leak.
Valve and bead
Soap the valve core, the stem base and both bead flanges. A bubble stream shows the path. A valve core that is loose or dirty is the easiest fix; a cracked rubber stem needs replacement.
A bead leak can be intermittent. If the soap test is negative cold, warm the tire gently and test again. A bead that is not fully seated can seal when cold and leak when warm.
Puncture and repair
Look for a nail, screw or cut. A small object can seal the hole while it is in place. A previous plug or patch can seep, especially if it was not installed from the inside.
If the leak started after a repair, have the tire dismounted and the repair inspected. Do not add sealant on top of an unknown repair.
Rim condition
Corrosion, a crack or a bent flange can prevent a seal. A cast wheel can crack at the bead seat after an impact. A cracked rim is a replacement.
Inspect the rim with the tire off if the leak persists. A shop can immerse the wheel and find a slow leak that soap misses.
What to do
If the loss is a few psi and tracks temperature, reset the pressure cold and monitor. If the tire is flat or loses pressure repeatedly, find the cause before riding. A slow leak can become a rapid loss at speed.
Do not over-inflate to compensate. That reduces the contact patch and can make the tire more vulnerable to impact damage.
Checklist
- Compare cold pressures at the same time of day.
- Soap the valve and bead.
- Look for a puncture or a previous repair.
- Check the rim for cracks and corrosion.
- Do not over-inflate to compensate.
- Have the wheel immersion-tested if the leak persists.
Questions
Is it normal for a tire to lose 2 psi overnight?
A small change can be temperature-related. If the loss continues after the temperature stabilises, it is a leak.
Why is only one tire losing pressure?
One tire may have a valve, bead or puncture issue. It may also be in a colder position or have a different rim condition. Test it individually.
Can a tire lose pressure through the rubber?
A tubeless tire can lose a small amount through the liner over time, but a rapid overnight loss is usually a valve, bead, puncture or rim issue.
Should I use sealant for an overnight leak?
No. Find the cause. Sealant can mask a structural problem and corrode the rim.