A tubeless bead seals by contact pressure between the tire and the rim. Anything that interrupts that contact, such as corrosion, dirt, old rubber, a scratch or a bent flange, can produce a slow leak. The leak may be intermittent: it can hold air cold and lose it when the tire flexes and warms. Testing with soapy water is simple, but the fix depends on whether the problem is contamination, rim damage or a damaged bead.
Bead leak causes
| Cause | Sign | Fix |
|---|---|---|
| Corrosion | Pitting under bead | Clean, assess rim |
| Dirt or old paste | Bubbles at flange | Clean and re-seat |
| Torn chafer | Visible damage | Replace tire |
| Bent flange | Gap at bead | Repair or replace wheel |
| Cracked rim | Hairline crack | Replace wheel |
| Aged valve | Bubbles at valve | Replace valve |
Contamination and corrosion
Old rubber, dried mounting paste, dirt and corrosion all prevent a clean seal. Alloy rims can corrode under the bead, lifting the surface and creating a path for air. The corrosion is often hidden until the tire is off.
Clean the bead seat with a non-abrasive method, inspect for pitting and remove loose material. Do not use a wire brush aggressively on an alloy rim; it can remove metal and make the seal worse.
Rim damage
A bent flange, a gouge or a crack at the bead seat can prevent a seal. A cast wheel that has taken a hard impact may be cracked on the inside, where it is hard to see. A cracked rim is a replacement, not a repair.
Check the rim with the tire off, using a light and a straight edge. If the flange is bent, a wheel repair specialist may be able to correct it, but a new wheel is often the safer choice.
Bead and mounting damage
A tire that was mounted with a lever too deep can have a torn chafer or a deformed bead. It may seal at first and leak later. A bead that has been run flat can also be deformed.
If the bead is damaged, replace the tire. Re-seating a damaged bead is not a repair. Use an approved mounting lubricant and the correct procedure next time.
Testing
With the wheel off the bike, put soapy water around the bead on both sides. Look for a stream of small bubbles. Rotate the wheel to check the whole circumference. Check the valve at the same time.
If the leak is not visible cold, ride gently to warm the tire and test again. A leak that only appears when warm is often a bead that is not fully seated or a rim that is distorted.
Fixing it properly
Clean and inspect the bead seat, fit a new valve if it is rubber and aged, lubricate correctly and seat the bead with controlled pressure. If it still leaks, dismount and inspect the bead and rim.
Do not use sealant to stop a bead leak. It can mask a structural problem and corrode the rim. If the rim or bead is damaged, replace the affected part.
Checklist
- Soap both bead flanges with the wheel off the bike.
- Check the valve at the same time.
- Clean the bead seat without removing metal.
- Inspect for cracks and bends.
- Replace a tire with a torn chafer or deformed bead.
- Never use sealant to hide a bead leak.
Questions
Why does my tubeless tire leak at the bead only when warm?
Heat increases pressure and flex, which can open a path that is closed when cold. The bead may not be fully seated or the rim may be distorted. Dismount and inspect.
Can I fix a bead leak with sealant?
No. Sealant can mask the leak temporarily and corrode the rim. Find and fix the cause.
Is a corroded rim safe to re-seat?
Only if the corrosion is superficial and the seat is smooth after cleaning. Deep pitting or a crack means the wheel should be repaired or replaced.
Should I replace the valve when fixing a bead leak?
Replace an aged rubber valve while the tire is off. It is inexpensive and removes another possible leak path.