A worn tire is a record of load, pressure, alignment and riding style. Centre wear points to pressure and straight-line mileage. Shoulder wear points to lean and low pressure. One-sided wear points to alignment, road camber or a habit. Cupping and scalloping point to damping and tread block movement. Reading the pattern before replacing the tire can prevent the next one from wearing the same way.
Wear patterns
| Pattern | Likely cause | Check |
|---|---|---|
| Centre strip | Pressure, mileage | Cold pressure |
| Worn shoulders | Low pressure, lean | Pressure, compound |
| One side | Alignment, camber | Wheel alignment |
| Cupping | Damping, balance | Forks, balance |
| Scalloping | Block flex, damping | Front end |
| Flat spot | Skid, storage | Braking, storage |
Centre and shoulders
A flat centre strip usually means too much pressure, a lot of upright mileage or a heavy load. Worn shoulders usually mean low pressure, a lot of cornering or a soft shoulder compound. Both can be normal for the bike's use, but both change the profile.
Measure the difference. A tire with a 2-3 mm difference between centre and shoulder is already out of shape, even if the lowest groove is above the limit.
One-sided wear
A tire worn more on one side can indicate rear-wheel misalignment, a bent fork or frame, a worn swingarm bearing or a rider who consistently leans one way. Road camber also contributes on a commuter that uses the same route.
Check alignment with a straight edge and inspect the swingarm and fork. If the bike has been down, have the frame and forks checked.
Cupping and scalloping
Cupping is a repeating diagonal scallop, usually on the front. It points to damping, pressure, balance or bearing play. Scalloping is a wavy edge on the tread blocks, often from tread block flex and a soft or under-damped front end.
Check the front end before replacing the tire. A new tire on worn forks can cup again quickly.
Diagonal steps and flat spots
A diagonal step across the tread can come from a combination of lean and braking, or from a tread block that is wearing on one edge. A single flat spot is usually a skid or long storage.
A step or flat spot that causes vibration is a replacement. A step that is mild is a reason to check pressure and riding style.
Using the pattern
Photograph the wear before the tire is removed. Note the pressure, load and routes. When you fit the next tire, change one variable at a time so you can see the effect.
If the wear is severe or one-sided, fix the cause before buying a premium tire. A good tire on a misaligned bike will wear badly too.
Checklist
- Measure centre and shoulders separately.
- Check for one-sided wear.
- Photograph the pattern before replacement.
- Check cold pressure and load.
- Inspect alignment and front-end damping.
- Fix the cause before fitting a new tire.
Questions
Why is my tire worn on one side only?
Alignment, road camber, a bent component or a consistent leaning habit can cause it. Check the rear wheel alignment and the front end.
Does uneven wear mean the tire is defective?
Usually not. It reflects load, pressure and setup. A manufacturing defect is more likely to show as a bulge or runout than as a wear pattern.
Can I ride a tire with uneven wear?
A mild pattern is tolerable. A distorted profile or a vibration is a reason to replace. Wet grip and handling are reduced.
Will a new tire fix the pattern?
Only if the cause is fixed. Pressure, alignment and damping problems will wear the new tire the same way.